The lane is made of tongue and grooved bed stock typically laid on edge or made of a synthetic material giving the appearance of boards sitting on their edges.
Bowling lane gutter width.
This is because the width of each individual lane sits at 3 feet and 6 inches while the length of the lane happens to be a whopping 60 feet long.
The combined width of the lane plus gutters should not be less than 60 in or more than 60 1 4 in.
On the left and right side of the lane are two gutters which sit lowered from the lane surface by 1 7 8.
The lane surface must also have a lengthwise tilt tolerance of 40 1000.
The bowling lane is 39 boards wide totaling 41 5 inches making each board 1 06 inches in width.
The surface of the lane must be free of contiguous grooves or ridges 40 1000 tolerance for crosswise tilt crowns and depressions.
Lane surface the surface must be free of all continuous grooves.
A maximum 40 1000th inch will be permitted in levelness and depth depression.
The lane is 41 1 2 in width.
The lane plus the gutters shall not be less than 60 inches nor more than 60 1 4 inches wide.
Its width according to the guidelines set by the international bowling federation is 41 5 in i e.
For single lane configurations you ll need a minimum width of 6 9.
For four lane projects the minimum width required is 22 8.
Lane width the lane shall be between 41 and 42 inches in width.
The gutter is 1 7 8 beneath the lane surface.
Each gutter is a full 9 1 4 in width fitting a bowling ball in them with a little extra wiggle room.
The center of the head pin spot is 60 feet plus or minus 1 2 to the foul line.